Fertraso Standing Fan 40cm 40W

A stand fan with a 40 cm blade on a height-adjustable pole, with a 40 W motor, three speeds, an oscillation function and a cross base of about 60 cm.

Setting the height is the point of this model

With a fixed fan, the furniture or the floor decides where the air leaves from. With this one you decide, and that is the reason to choose a stand over a floor model of the same wattage.

The height you choose determines which layer you set moving. Put it low and it works below the crop. Put it high and it mixes the warm layer collecting under the ceiling with the cooler air beneath. If your setup changes through the grow because the crop gets taller, you raise the fan with it instead of relocating it.

What the cross base means for your floor

The base is about 60 cm across. That is deliberate: a fan standing at height and oscillating needs a wide footing so it does not walk or topple. Do count those 60 cm into your layout, because it is more floor area than a floor model takes, and in an 80 by 80 tent that is a considerable share.

The head tilts up and down, and the oscillation can be switched on and off. Off, you aim it at one area; on, it spreads across the width.

Technical Specifications:

• Model: stand fan
• Blade diameter: 40 cm / 16 inch
• Motor: 40 W
• Speeds: 3
• Blades: 3 aerodynamic blades
• Height: adjustable
• Oscillation: switchable on and off
• Tilt: head adjustable up and down
• Base: stable cross base
• Base width: about 60 cm

Frequently asked questions

Why a stand rather than a floor model?
Because you choose the height the air leaves from, and that height decides which layer you mix.

How much space does the base need?
About 60 cm. In a small tent that is a noticeable share of your floor.

Can the oscillation be turned off?
Yes. Off you aim it at one area, on it spreads across the width.

Can I raise it as the crop grows?
Yes, that is exactly what the adjustable height is for.